SonTek/YSI
ADVField Software Manual (September 1, 2001) 56
• Corr1, Corr2, Corr3 - Correlation components of selected burst as a percentage (if left-axis =
Correlation)
• Corr StD1, Corr StD2, Corr StD3 - Correlation standard deviation components of selected
burst as a percentage (if left-axis = Corr StD)
• Speed - Averaged water-current speed for selected burst in cm/s (if left-axis = Speed)
• Dir - Averaged water-current direction for selected burst in degrees (if left-axis = Direction)
• Temp - Averaged water temperature for selected burst in degrees C (if left-axis = Temp.)
• Temp StD - Temperature standard deviation for selected burst in degrees C (if left-axis =
Temp StD)
• Press - Averaged pressure for selected burst in dbar (if left-axis = Pressure or Ext Pressure)
• Ext P StD - Pressure standard deviation for selected burst in dbar (if left-axis = Press StD or
Ext Press StD)
• Head - averaged heading for selected burst in degrees (if left-axis = Heading)
• H StD - Heading standard deviation for selected burst in degrees (if left-axis = Heading StD)
• Pitch - Averaged pitch for selected burst in degrees (if left-axis = Pitch)
• P StD - Pitch standard deviation for selected burst in degrees (if left-axis = Pitch StD)
• Roll - Averaged roll for selected burst in degrees (if left-axis = Roll)
• R StD - Roll standard deviation for selected burst in degrees (if left-axis = Roll StD)
• CTD Sal - Averaged CTD salinity value in parts-per-thousand (ppt) for selected burst (if left-
axis = CTD Salinity)
• CTD Temp - Averaged CTD temperature value in degrees C for selected burst (if left-axis =
CTD Temp)
• CTD Cond - Averaged CTD conductivity value in Siemens/meter for selected burst (if left-
axis = CTD Conduct)
• CTD Depth - Averaged CTD depth value in meters for selected burst (if left-axis = CTD
Depth)
• Ext1, Ext2, Ext3 - Averaged reading from the user-defined External Sensor 1/2/3 in counts
for selected burst (if left-axis = Ext Sen1/2/3)
• Ext1StD, Ext2StD, Ext3StD - Averaged reading from the user-defined External Sensor 1/2/3
standard deviation in counts for selected burst (if left-axis = Ext Sen1/2/3 StD)
• Dist - Averaged distance from either the probe to the boundary or from the sampling volume
to the boundary for selected burst in cm (depends on where left-axis = Dist:Probe-Boundary
or Dist:SVol-Boundary)
• Volt - Averaged battery voltage during selected burst in volts (if left-axis = Battery Voltage)
12.2.4. Sample Tabular Data
Information about each sample within the selected burst can be found in the Sample Information
dialog box (lower right, but is movable). You can move this dialog box by clicking on and drag-
ging the title bar (or "gripper") located at the top of the box. The Sample Information dialog box
includes the following tabular data:
• Sample number - Note: You can quickly move to a specific sample number within the se-
lected burst by double-clicking on the sample number and entering a new value.
• V1/X/E, V2/Y/N, V3/Z/U - Velocity components of the selected sample in cm/s. The specific
component depends on the selected velocity coordinate system.
• Amp1/Amp2/Amp3 - Signal amplitude components of the selected sample in counts
To Next Page
Loading...
Need help?
General
