SonTek/YSI
28
ADVField Operation Manual (September 1, 2001)
3.4. Help Commands
The ADVField direct-command interface contains several on-line help commands. These are de-
signed such that, by starting with
Help
(or
H
or
?
), you are led through a series of menus that
show all ADVField commands. The following help commands display all commands you would
normally use for any aspect of ADVField operation. Entering any of these commands at the di-
rect-command prompt (
>
) will display the appropriate help menus.
•
Help System
– General system commands (§3.5)
•
Help Setup
– Real-time data collection commands (§3.6)
•
Help Deploy
– Autonomous deployment commands (§3.7)
•
Help Recorder
– Data recorder commands (§3.8)
•
Help Sensor
– Peripheral sensor commands (§3.9)
•
Help Compass
– Compass/tilt sensor commands (§3.9.5)
•
Help Show
– Commands to display system configuration (§3.11)
To Next Page
Loading...
Need help?
General
