SonTek/YSI
ADVField Software Manual (September 1, 2001) 57
• Mean Amp - The mean of the signal amplitude components of the selected sample in counts
• Corr1/Corr2/Corr3 - Correlation components of the selected sample as a percentage
• Mean Corr - The mean of the correlation components of the selected sample as a percentage
• Heading - Averaged heading for the selected sample in degrees
• Pitch - Averaged pitch for the selected sample in degrees
• Roll - Averaged roll for the selected sample in degrees
• Temp - Averaged water temperature for the selected sample in degrees C
• Press - Averaged pressure for the selected sample in dbar
12.3. Menu Item Descriptions
This section explains each ViewHydra / ViewHydraPro menu item in detail. Note that items
marked with an asterisk (*) only apply to the ViewHydraPro program.
12.3.1. File Menu
The File Menu contains the following options:
• Open… (Ctrl+O) - Opens a Hydra data file (*.adr) for display.
• Close - Closes the data file, but does not exit the ViewHydra program.
• Print (Ctrl+P) - Prints the currently selected .adr file to the selected printer.
Notes:
(1) A "landscape" printout is recommended.
(2) If the printout is not of good quality, you can copy the display to the clipboard, and then
paste it into another program (e.g.; graphic editor, presentation program, word processor)
for further processing. See the Edit|Copy Screen to Clipboard (§12.3.2) option.
• Print Preview - Lets you view the graphic display as it will look when printed. Depending on
the speed of your computer, and the number of data points in your graph, it may take from
several seconds to several minutes before the preview is displayed.
• Print Setup - Lets you modify the printer selection and its parameters before printing.
• Export Data - Allows you to create ASCII (or MatLab* with ViewHydraPro) file outputs for
any or all of the items shown in Table 6. Individual files are created using the data file name
with the appropriate extension. You can choose to create a file just for the selected variable
(Export Selected Variable), or to create files for all the output variables at the same time (Ex-
port All Variables).
To create the ASCII file output(s): (a) Enter the path where you want to save the file(s), (b)
Enter the file name (but not the extension), (c) Enter the burst range to process, (d) Enter the
desired output variables and format (ASCII or Matlab*) to export the selected variable, or
export all variables, (e) Press the appropriate Export button.
• Configuration - Allows you to activate various settings to save user workspace and default
display preferences. Use Workspaces allows you to retain your settings from session to ses-
sion for the active data file. Save Current Display Settings as Default lets you set the default
display for all data files that you open; however, if the file you are opening already has a
saved workspace, the workspace settings will override these default settings.
• 1, 2, 3, 4 - Lists the last four .adr files that were accessed. Selecting one of these items will
open the associated file.
• Exit - Closes the data file and then exits the ViewHydra program.
To Next Page
Loading...
Need help?
General
