YSI SonTek ADVField User Manual

SonTek/YSI
ADVField/Hydra Operation Manual (September 1, 2001) 45
3.11. Show Commands
There are four “show” commands to display current ADVField parameter settings. Samples of
these commands and their outputs are show below.
Note: The examples shown here may differ for your system. The number of items shown by each
Show command may vary depending on the firmware version being used and depending on the
optional sensors that you have installed on your system.
Show Conf
• Displays the current ADVField hardware configuration.
• Example:
>show conf
HARDWARE CONFIGURATION PARAMETERS
---------------------------------
Probe serial # --------------- A383F
Probe type ------------------- Micro DOWN XYZ 5cm
Probe Orientation ------------ DOWN
Compass sensor ----------- NO
Recorder sensor ----------- YES
Temperature sensor ----------- YES
Pressure sensor ----------- NO
PressOffset (dbar) ---------- 0.000000
PressScale (dbar/count) ---- 0.000000
PressScale_2 (pdbar/count^2) - 0
External Pressure Sensor ----- NO
External sensors ---------- STANDARD
Microcat CTD ----------------- NO
LISST Sensor ----------------- NO
Show System
• Displays the current system parameters.
• Example:
>show system
CURRENT SYSTEM PARAMETERS
-------------------------
CPU Version - ADV 7.9
DSP Version - DSP 4.0
Date -------- 2001/07/05
Time -------- 17:50:37
OutFormat --- BINARY
OutMode ----- POLLED
Show Setup
• Displays the current real-time data collection parameters.
• Example:
>show setup
CURRENT ADV SETUP PARAMETERS
----------------------------
Temp -------- 22.7 deg C
Sal --------- 0.0 ppt
TempMode ---- USER
Sound Speed - 1490.3 m/s
VelRange ---- 3 (+-100 cm/s)
SampRate ---- 2.00 Hz
CoordSystem - XYZ
SyncMode ---- DISABLE

YSI SonTek ADVField Specifications

General

Brand	YSI
Model	SonTek ADVField
Category	Measuring Instruments
Language	English