SonTek/YSI
ADVField/Hydra Operation Manual (September 1, 2001) 27
Table 9. Sensor Commands (§3.9)
Command Short Function
Sensor Show most recent temperature, pressure, and battery voltage
Sensor CONT Show temperature, pressure, and battery voltage continuously
PressScale Output scaling factor used to convert pressure counts to dBar
PressOffset Output offset used to convert pressure counts to dBar
CTD
Show most recent temperature (°C), conductivity (S/m), pressure
(decibar), and salinity (ppt) data from external CTD sensor
CTD CONT Show CTD data continuously
CTD Talk Establish direct serial communications with CTD sensor
ExtSensorInstalled Enables/Disables external sensor
ExtSensor [CONT] Show most recent data from external sensor [continuously]
Druck [CONT] Show most recent data from Druck pressure sensor [continuously]
Paros [CONT] Show most recent data from Paros pressure sensor [continuously]
ParosFreq [CONT] Show most recent data from Paros pressure sensor [continuously]
ExtPressureSensorInstalled
Enables/Disables external pressure sensor
CTDSensorInstalled
Enables/Disables external CTD sensor
LisstSensorInstalled
Enables/Disables external LISST-100 sensor
Table 10. Compass Commands (§3.9.5)
Command Short Function
Compass [CONT] Show most recent heading, pitch, and roll [continuously]
Compass CAL Perform compass/tilt sensor calibration
Table 11. Show Commands (§3.11)
Command Short Function
Show Conf S Conf Display hardware configuration parameters
Show System S System Display general system parameters
Show Setup S Setup Display real-time data collection parameters
Show Deploy S Deploy Display autonomous deployment parameters
Show Druck S Druck Display frequency pressure sensor calibration
Table 12. Run Time Commands (§3.12)
Command Short Function
+++ Return ADVField to command mode (stop data collection)
To Next Page
Loading...
Need help?
General
