SonTek/YSI
26
ADVField Operation Manual (September 1, 2001)
Table 6. Setup Commands (§3.6)
Command Short Function Parameters
Temp <temperature>
Set default temperature (°C)
d.d
Sal <salinity> Set default salinity (ppt) d.d
VelRange <range> VR Set ADV velocity range value (index) d <0 to 4>
SampRate <rate> SR Set ADV sampling rate (Hz) d.d
CoordSystem<system> CY Set coordinate system for velocity data BEAM,
XYZ,
ENU
TempMode <mode> TM Set temperature used in sound speed calculations USER,
MEASURED
SyncMode <mode> SM Specify external synchronization mode (real-
time data acquisition only)
START, SAM-
PLE
, DISABLE
Table 7. Deployment Commands (§3.7)
Command Short Function Parameters
Deployment <name> Set deployment file name ASCII text
Comments Enter deployment comments ASCII text
StartDate <date> SD Set deployment start date yy/mm/dd
StartTime <time> ST Set deployment start time hh:mm:ss
SampRate <rate> SR Set ADV sampling rate (Hz) d.d
BurstInterval<seconds> BI Set time between bursts (seconds) d
SamplesPerBurst <num.> SB Set number of samples per burst d
RecordAmpCorr <mode> Set mode to record amplitude and correlation for
all beams with each sample
YES, NO
RecordCompass <mode> Set mode to record compass/tilt sensor data with
each sample
YES, NO
RecordSensor <mode> Set mode to record temperature and pressure
data with each sample
YES, NO
RecordStat <mode> Set mode to record statistics with each burst YES, NO
RecordExtSensor<mode> Set mode to record external sensor data YES, NO
RecordExtPress <mode> Set mode to record external pressure sensor data YES, NO
RecordCTD <mode> Set mode to record external CTD data YES, NO
RecordLISST <mode> Set mode to record LISST-100 sensor data YES, NO
Table 8. Recorder Commands (§3.8)
Command Short Function
LD or Dir List deployments currently on recorder
Format Erase all data from recorder
RecStatus Show recorder size and type
To Next Page
Loading...
Need help?
General
