SonTek/YSI
ADVField/Hydra Operation Manual (September 1, 2001) 25
Table 4. Help Commands (§3.4)
Command Short Function
Help H or ? Information about available help categories
Help System H/? System Information about general system commands
Help Setup H/? Setup Information about real-time data collection commands
Help Deploy H/? Deploy Information about autonomous deployment commands
Help Recorder H/? Recorder Information about internal recorder commands
Help Sensor H/? Sensor Information about peripheral sensor commands
Help Compass H/? Compass Information about compass/tilt sensor commands
Help CTD H/? CTD Information about CTD sensor commands
Help Show H/? Show Information on how to display system configuration
Table 5. System Commands (§3.5)
Command Short Function Parameters
Start Start real-time data collection (enter data acqui-
sition mode)
Deploy Start autonomous deployment (enter deployment
mode)
SaveSetup Save current parameters to EEPROM
Cal Calibrate analog output voltages
Defaults DEF Set all parameters to factory defaults
Ver Show CPU firmware version
DSPVer Show DSP firmware version
BoardRev Show electronics PC board revision
SerNum Return ADV probe serial number
Boundary Measure and return distance to boundary
Date <date> Set/display system clock date yy/mm/dd
Time <time> Set/display system clock time hh:mm:ss
PowerOff Place ADV in sleep mode
OutFormat <format> OF Specify output data format
ASCII, BINARY
The following system commands are not shown in the ADVField on-line help
Setup Prepare the ADV to begin data collection
Go Start data collection immediately (enter data ac-
quisition mode)
To Next Page
Loading...
Need help?
General
