SonTek/YSI
ADVField Software Manual (September 1, 2001) 49
Basic Downloading Instructions
• Click
Connect
to establish communication and display the recorder’s directory.
• Specify a destination directory on the bottom right (or use the
Browse
button).
• Select one or more files from the display list. Files can be selected several ways.
o Click a file to select a single file.
o Hold the Control or Shift key and click a series of files to select more than one file.
o Click
Select All
to select all files on the recorder.
• Click
Download
to copy all selected files to the specified directory.
• Watch the program status area on the left as files are downloaded.
Formatting the Internal Recorder
• The
Format
button on the bottom right erases the internal recorder.
• Be certain that all files have been downloaded and backed up before erasing the recorder.
• Files cannot be recovered after the recorder has been erased.
• To erase the recorder, click
Format
, and then
OK
to confirm your decision when the warning
window appears.
Download Baud Rate
• Recorder uses a higher baud rate to download data files (compared to the one used for stan-
dard system communication). The default download baud rate is 115200.
• High baud rates can only be used with high-quality, relatively short cables (such as the cables
normally supplied with the ADVField).
• If you have trouble downloading data, try using a slower download baud rate.
Communication parameters
• COM port and baud rate settings can be modified in the upper left area of the screen.
• Access to all communication settings (data bits, stop bits, etc.) can be set using the
Set-
tings|Port Settings
menu.
RS485 Multiple System Operation
• The top center area of the screen specifies the RS485 system communication address.
• An address setting of 0 indicates RS485 is not being used. An address setting of from 1
through 15 prefaces all commands with that system address.
• See the ADVField Operation Manual for details on RS485 multi-system operation.