SonTek/YSI
Using Frequency Pressure Sensors with SonTek/YSI Systems (December 2001)
5
Show DRUCK or Show PAROSFREQ
•
Displays
DRUCK
/
PAROSFREQ
calibration data in the following format:
Druck pressure sensor calibration data
--------------------------------------
SN: 1276950
F0: 1.200e+07
X: 8.4410000e+03
Y: 5.6000000e+02
T0: -1.0000000e+01
D0: 6.2900000e+02
DT: -2.2100000e+00
K00: 1.5962190e+03 K01: -2.6693000e-02
K10: 1.6820332e+00 K11: -1.0395800e-05
K20: 3.9933779e-04 K21: -4.9470601e-09
K30: 8.0327140e-08 K31: -1.4093000e-12
K40: 1.7388157e-11 K41: 2.2691999e-16
K50: 2.5953699e-15 K51: 1.3877999e-19
K02: 3.1005999e-05 K03: 2.6474001e-07
K12: 1.8332999e-08 K13: 8.2459997e-11
K22: 1.6572001e-11 K23: -1.7079999e-14
K32: -7.7020003e-15 K33: -9.9870002e-17
K42: -4.0642002e-18 K43: -1.0678000e-19
K52: 5.3660002e-21 K53: -2.8249999e-23
4.2. Argonaut SL/XR
The following command applies to Argonaut SL and XR systems that have an external pressure
sensor installed.
ExtPressInstalled [NONE|PAROS|DRUCK]
•
Selects or disables the frequency pressure sensor type.
•
Set at the factory. Does not need to be changed.
To Next Page
Loading...
Need help?
General
