Getting Started
18
Figure 4 Scan Key
Setting Up the Device
To start using the device for the first time:
• Charge the battery to at least 30% capacity.
NOTE: When the device is shipped from the factory, it is placed into Ship Mode, where the device enters
its lowest possible power state. The device can exit Ship Mode by docking it in a powered cradle or in a
powered USB cable. Fully charging the battery pack to 100% is recommended immediately after exiting
ship mode to calibrate the state of charge.
Charging the Battery
Use one of the following accessories to charge the PS20.
NOTE: Ensure that you follow the guidelines for battery safety described in the PS20 Product Reference
Guide.
Scan Key
Table 3 Charging Cradles
Description Part Number
Cables
DC
Cable
Interconnect
Cable
Extension
Cable
Single Slot Cradle CRD-MC18-1SLOT-01 CBL-DC-394A1-01
CBL-DC-393A1-02
CBL-DC-392A1-02
25-66431-01R
25-66430-01R
_____
High Density (HD) Three Slot Cradle
(Locking)
CRD-MC18-3SLCKH-01 CBL-DC-394A1-01
CBL-DC-393A1-02
CBL-DC-392A1-02
25-66431-01R
25-66430-01R
CBL-MC18-
EXINT1-01
High Density (HD) Three Slot Cradle
(Non-Locking)
CRD-MC18-SLOTH-01 CBL-DC-394A1-01
CBL-DC-393A1-02
CBL-DC-392A1-02
25-66431-01R
25-66430-01R
CBL-MC18-
EXINT1-01
Super High Density (HD) Three Slot
Cradle (Locking)
CRD-MC18-3SLCKS-01 CBL-DC-394A1-01
CBL-DC-393A1-02
CBL-DC-392A1-02
25-66431-01R
25-66430-01R
CBL-MC18-
EXINT1-01
MC18 Product Reference Guide.book Page 18 Tuesday, June 30, 2020 9:07 PM