INSTRUMENT DESCRIPTION
Carl Zeiss Operation and Functional Elements on the Microscope Axio Vert.A1
26 431030-7044-001 05/2012
2.5 Operation and Functional Elements on the Microscope
2.5.1 Axio Vert.A1 Stand for Transmitted Light
Legend to Fig. 2-6:
1 Eyepieces
2 Binocular part of the tube
3 Transmitted light illumination (either with a halogen or an LED illuminator)
4 Two-position filter slider mounted on the carrier for transmitted light illumination
5 Condenser (either condensers with modulator disk or condensers with slider slot)
6 232 mm x 230 mm specimen stage
7 Focusing drive - fine focusing (right-hand side)
8 Focusing drive - coarse focusing (right-hand side)
9 Illumination intensity of transmitted light on/off
- Turn the control button to increase or lower illumination intensity.
- Press the control button to switch transmitted light illumination on or off.
10 permanent/ECO switch:
- permanent position: Transmitted light illumination is switched on permanently, with
the ECO power-saving function not activated.
- ECO position: The ECO power-saving function is activated.
11 Power indicator (blue)
12 Slot for contrast sliders with analyzer or with PlasDIC module (left-hand and right-hand sides)
13 Slot for DIC sliders or PlasDIC sliders in the objective nosepiece
14 Knurled ring of the objective nosepiece
15 Stop for the vertical adjusting range of the focusing drive
16 Focusing drive - coarse focusing (left-hand side)
17 Focusing drive - fine focusing (left-hand side)
18 On / Off switch
19 Slot for contrast sliders with analyzer or with PlasDIC module (left-hand and right-hand sides)
To Next Page
Loading...
