OPERATION
Axio Vert.A1
Use of Objectives Carl Zeiss
05/2012 431030-7044-001 73
4.5 Use of Objectives
Objectives for Bright Field and PlasDIC
− EC Plan-Neofluar 1.25x
− EC Plan-Neofluar 2.5x
− A-Plan 2.5x
− A-Plan 5x
− LD A-Plan 10x to 63x (also suitable for phase contrast if available as Ph objective)
− LD Plan-Neofluar Korr 20x, 40x, 63x (also suitable for phase contrast if available as Ph objective)
When Ph objectives are utilized for PlasDIC, imaging quality is slightly diminished.
Objectives for the VAREL, Phase Contrast, DIC or iHMC Contrast Techniques
In order for the objectives to be used for these contrast techniques, the objectives must be expressly
approved for them. (See identifier on the objective.)
4.6 ECO Power-Saving Function
The ECO function should be used for short-time microscope use. This will save energy and extend the
service life of the transmitted light illumination (halogen lamp).
Activating the Power-Saving Function
• Put the permanent/ECO (Fig. 2-8/15) switch into the ECO position.
The illumination will automatically shut off after approximately 15 minutes of operation and go into the
stand-by mode.
• You can terminate the power-saving function by pressing the On/off control button (Fig. 2-8/13), so
that the illumination gets switched on again.
• If the On/off control button is actuated during the operation of the microscope, the power-saving
function will be activated immediately, with the illumination turned off. Pressing the On/off button
once more will switch the illumination on again.
Deactivating the Power-Saving Function (Normal Operating Mode)
• Put the permanent/ECO switch into the permanent position.
The illumination will stay switched on permanently. You can turn the illumination on and off by pressing
the On/off control button.
To Next Page
Loading...
