Zoom F4 - Setting the Attack Time; Setting the Release Time

Output settings
Output Limiter
100
Output Limiter (continued)
Setting the release time
This sets the amount of time until compression stops after
the input signal goes below the threshold.
5. Use e to select Release
Time, and press E.
6. Use e to adjust the time,
and press m.
HINT
This can be set from 1 to 500 ms.
Setting the attack time
This sets the amount of time until compression starts after
the input signal exceeds the threshold.
5. Use e to select Attack
Time, and press E.
6. Use e to adjust the time,
and press m.
HINT
This can be set from 1 to 4 ms.