Input settings
Input limiter
78
Input limiter (continued)
NOTE
• Limiter operation is linked for tracks that have stereo link
or MS stereo link enabled. If the signal for either linked
channel reaches the threshold, the limiter will operate on
both tracks.
• When the limiter is operating, the end of the level meter
and the mixer limiter indicator light on the display.
Setting the release time
This sets the amount of time until compression stops after
the input signal goes below the threshold.
5. Use e to select Release
Time, and press E.
6. Use e to adjust the time,
and press m.
HINT
This can be set from 1 to 500 ms.
To Next Page
Loading...
