Output settings
Setting signals sent to the output jacks (Routing)
90
Setting signals sent to the output jacks (Routing)
1. Press m.
2. Use e to select OUTPUT,
and press E.
3. Use e to select Routing,
and press E.
▶ Continue to one of the following procedures.
Setting signals sent to the headphone output .............................. P.90
Setting signals sent to the MAIN OUT ........................................... P.92
Setting signals sent to the SUB OUT ............................................. P.93
Setting signals sent to the headphone output
4. Use e to select Headphone
Routing, and press E.
5. Use e to select the tracks/outputs for routing,
and press E.
Press to set tracks 1–6 to prefader (cancel MS)
Mid-side
stereo
monitoring
Press to cycle through settings
• Change tracks 1–6 to postfader (cancel others)
• Change L/R to postfader (cancel others)
• Change M1/M2 to postfader (cancel others)
• Change S1/S2 to postfader (cancel others)
(cancel MS)
Prefader selected
Postfader selected
Off
Clear all settings
Mono mix
Tracks routed to the left
headphone channel
Tracks routed to the right
headphone channel
You can set the type of signal sent to the headphone output, MAIN OUT and SUB OUT to either prefader or postfader for each
track.
To Next Page
Loading...
Need help?
General
