Zoom F4 - Input Limiter

Input settings
Input limiter
F
Multi Track Field Recorder
75
Input limiter
The limiter can prevent distortion by controlling input signals
that have excessively high levels.
Threshold
Level
Original
signal
Limited
signal
Attack
time
Release
time
Time
When the limiter is ON, if the input signal level exceeds the
set threshold value, the signal level will be suppressed to pre-
vent the sound from distorting.
The attack time is how long after the signal exceeds the
threshold until the limiter starts operating. The release time
is how long after the signal goes below the threshold until
the limiter stops operating. Change these two parameters to
adjust the sound quality.
HINT
• The F uses a newly-designed limiter. This limiter has 10dB of
headroom, preventing distortion and allowing it to keep signals
below the set threshold even more than ordinary limiters.
• The ratio of the F limiter is 20:1.
1. Press m.
2. Use e to select INPUT,
and press E.
3. Use e to select Input Lim-
iter, and press E.
4. Use e to select the track,
and press E.
HINT
Select All to set all the tracks at the same time.