ZyXEL Communications 5 Series - Figure 137 WIRELESS > Wi-Fi > Wireless Card: no Access 802.1 X + Static WEP; No Access 802.1 X + no WEP; Table 65 WIRELESS > Wi-Fi > Wireless Card: no Access 802.1 X + Static WEP

Chapter 12 Wireless Screens
ZyWALL 5/35/70 Series User’s Guide
242
Figure 137 WIRELESS > Wi-Fi > Wireless Card: No Access 802.1x + Static WEP
The following wireless LAN security fields become available when you select No Access
802.1x + Static WEP in the Security drop down list-box.
12.2.8 No Access 802.1x + No WEP
Click the NETWORK > WIRELESS CARD or NETWORK > Wi-Fi to display the
Wireless Card screen. Select No Access 802.1x + No WEP to deny all wireless stations
access to your wired network and block all wireless stations from communicating with the
ZyWALL.
Table 65 WIRELESS > Wi-Fi > Wireless Card: No Access 802.1x + Static WEP
LABEL DESCRIPTION
Security Select No Access 802.1x + Static WEP from the drop-down list.
WEP
Encryption
WEP (Wired Equivalent Privacy) provides data encryption to prevent unauthorized
wireless stations from accessing data transmitted over the wireless network.
Select 64-bit WEP or 128-bit WEP to enable data encryption.
Key 1 to Key 4 If you chose 64-bit WEP in the WEP Encryption field, then enter any 5 characters
(ASCII string) or 10 hexadecimal characters ("0-9", "A-F") preceded by 0x for each
key.
If you chose 128-bit WEP in the WEP Encryption field, then enter 13 characters
(ASCII string) or 26 hexadecimal characters ("0-9", "A-F") preceded by 0x for each
key.
There are four data encryption keys to secure your data from eavesdropping by
unauthorized wireless users. The values for the keys must be set up exactly the same
on the access points as they are on the wireless stations.
Apply Click Apply to save your changes back to the ZyWALL.
Reset Click Reset to begin configuring this screen afresh.