Chapter 41 Wireless Setup
ZyWALL 5/35/70 Series User’s Guide
656
The following table describes the fields in this menu.
41.2 TCP/IP Setup
For more detailed information about RIP setup, IP Multicast and IP alias, please refer to
Chapter 7 on page 149.
41.2.1 IP Address
From the main menu, enter 7 to open Menu 7 - WLAN Setup to configure TCP/IP (RFC
1155).
Figure 397 Menu 7: WLAN Setup
From menu 7, select the submenu option 2. TCP/IP and DHCP Setup and press [ENTER].
The screen now displays
Menu 7.2 - TCP/IP and DHCP Ethernet Setup, as shown next.
Table 234 Menu 7.1.1: WLAN MAC Address Filter
FIELD DESCRIPTION
Active To enable MAC address filtering, press [SPACE BAR] to select Yes and press
[ENTER].
Filter Action Define the filter action for the list of MAC addresses in the MAC address filter table.
To deny access to the ZyWALL, press [SPACE BAR] to select Deny Association
and press [ENTER]. MAC addresses not listed will be allowed to access the router.
The default action, Allowed Association, permits association with the ZyWALL.
MAC addresses not listed will be denied access to the router.
MAC Address
Filter
Address 1..12 Enter the MAC addresses (in XX:XX:XX:XX:XX:XX format) of the client computers
that are allowed or denied access to the ZyWALL in these address fields.
When you have completed this menu, press [ENTER] at the prompt [Press ENTER to Confirm…] to
save your configuration, or press [ESC] at any time to cancel.
Menu 7 - WLAN Setup
1. Wireless Setup
2. TCP/IP and DHCP Setup
Enter Menu Selection Number:
To Next Page
Loading...
