Chapter 31 Reports Screens
ZyWALL 5/35/70 Series User’s Guide
552
Figure 335 REPORTS > E-mail Report
The following table describes the labels in this screen.
Table 169 REPORTS > E-mail Report
LABEL DESCRIPTION
General Setup
Enable E-mail
Report
Select this to turn on the e-mail report feature. You must then specify a valid e-mail
server in order to send reports.
Clear report
statistics after
sending the
report e-mail
Select this to clear current records of IDP, anti-virus and anti-spam statistics
(available in the Reports screens) once the report has been sent.
E-mail Settings
Mail Server Enter the server name or the IP address of the mail server for the e-mail address
specified in the Mail Sender field. If this field is left blank, report files will not be sent
via e-mail.
Mail Subject Type a descriptive subject here to be included in the report e-mail subject header.
Mail Sender Enter the e-mail address that you want to be in the from/sender line of the diagnostic
e-mail message that the ZyWALL sends. If you activate SMTP authentication, the e-
mail address must be able to be authenticated by the mail server as well.
Send Report to Report files are sent to the e-mail address specified in this field. If this field is left
blank, report files will not be sent via e-mail.
SMTP
Authentication
SMTP (Simple Mail Transfer Protocol) is the message-exchange standard for the
Internet. SMTP enables you to move messages from one e-mail server to another.
Select the check box to activate SMTP authentication. If mail server authentication is
needed but this feature is disabled, you will not receive the report files.
User Name Enter the user name (up to 63 characters) (usually the user name of a mail account
you specified in the Mail Sender field).
Password Enter the password associated with the user name above.
To Next Page
Loading...
