ZyXEL Communications 5 Series - The IP Static Route Screen

Chapter 23 Static Route Screens
ZyWALL 5/35/70 Series User’s Guide
452
• Use the IP Static Route Edit screen (Section 23.2.1 on page 454) to configure the
required information for a static route.
23.2 The IP Static Route Screen
Click ADVANCED > STATIC ROUTE to open the IP Static Route screen (some of the
screen’s blank rows are not shown).
The first two static route entries are for default WAN 1 and WAN 2 routes on a ZyWALL with
multiple WAN interfaces. You cannot modify or delete a static default route.
The default route is disabled after you change the static WAN IP address to a dynamic WAN
IP address.