ZyXEL Communications 5 Series - Figure 266 ADVANCED > POLICY ROUTE > Edit; Table 138 ADVANCED > POLICY ROUTE > Edit

Chapter 24 Policy Route Screens
ZyWALL 5/35/70 Series User’s Guide
461
Figure 266 ADVANCED > POLICY ROUTE > Edit
The following table describes the labels in this screen.
Table 138 ADVANCED > POLICY ROUTE > Edit
LABEL DESCRIPTION
Criteria
Active Select the check box to activate the policy.
Rule Index This is the index number of the policy route.
IP Protocol Select Predefined and then the IP protocol from ALL(0), ICMP(1), IGMP(2),
TCP(6), UDP(17), GRE(47), ESP(50) or AH(51).
Otherwise, select Custom and enter a number from 0 to 255.
Type of Service Prioritize incoming network traffic by choosing from Any, Normal, Min Delay, Max
Thruput, Max Reliable or Mix Cost.
Precedence Precedence value of the incoming packet. Select a value from 0 to 7 or Any.
Packet Length Type a length of packet (in bytes). The operators in the Length Comparison field
apply to incoming packets of this length.