Chapter 48 System Information & Diagnosis
ZyWALL 5/35/70 Series User’s Guide
715
48.3 System Information and Console Port Speed
This section describes your system and allows you to choose different console port speeds. To
get to the System Information and Console Port Speed:
1 Enter 24 to go to Menu 24 - System Maintenance.
2 Enter 2 to open Menu 24.2 - System Information and Console Port Speed.
3 From this menu you have two choices as shown in the next figure:
Figure 453 Menu 24.2: System Information and Console Port Speed
48.3.1 System Information
System Information gives you information about your system as shown below. More
specifically, it gives you information on your routing protocol, Ethernet address, IP address,
etc.
Cols This is the number of collisions on this port.
Tx B/s This field shows the transmission speed in Bytes per second on this port.
Rx B/s This field shows the reception speed in Bytes per second on this port.
Up Time This is the total amount of time the line has been up.
Ethernet Address This is the MAC address of the port listed on the left.
IP Address This is the IP address of the port listed on the left.
IP Mask This is the IP mask of the port listed on the left.
DHCP This is the DHCP setting of the port listed on the left.
System up Time This is the total time the ZyWALL has been on.
CARD bridged to This field shows whether the wireless card is set to be part of the LAN, DMZ or
WLAN.
You may enter 1 to drop the WAN connection, 9 to reset the counters or [ESC] to return to menu 24.
Table 252 System Maintenance: Status Menu Fields (continued)
FIELD DESCRIPTION
Menu 24.2 - System Information and Console Port Speed
1. System Information
2. Console Port Speed
Please enter selection:
To Next Page
Loading...
