ZyXEL Communications 5 Series - The Restart Screen; The Diagnostics Screen; Figure 356 Reset Warning Message; Figure 357 MAINTENANCE > Restart

Chapter 33 Maintenance Screens
ZyWALL 5/35/70 Series User’s Guide
599
Figure 356 Reset Warning Message
You can also press the hardware RESET button to reset the factory defaults of your
ZyWALL. Refer to Section 3.3 on page 63 for more information on the RESET button.
33.10 The Restart Screen
System restart allows you to reboot the ZyWALL without turning the power off.
Click MAINTENANCE > Restart. Click Restart to have the ZyWALL reboot. Restart is
different to reset; (see Section on page 598) reset returns the device to its default
configuration.
Figure 357 MAINTENANCE > Restart
33.11 The Diagnostics Screen
Use the Diagnostics screen to have the ZyWALL generate and send diagnostic files by e-mail
and/or the console port. The diagnostics files contain the ZyWALL’s configuration and
diagnostic information. You may need to generate this file and send it to customer support
during troubleshooting.
Click MAINTENANCE > Diagnostics to open the following screen.
" The ZyWALL sends only one diagnostic e-mail within five minutes (unless you
click Perform Diagnostics Now).