Chapter 33 Maintenance Screens
ZyWALL 5/35/70 Series User’s Guide
595
33.8 The F/W Upload Screen
Find firmware at www.zyxel.com in a file that (usually) uses the system model name with a
.bin extension, for example, “zywall.bin”. The upload process uses HTTP (Hypertext Transfer
Protocol) and may take up to two minutes. After a successful upload, the system will reboot.
See Section 49.5 on page 733 for upgrading firmware using FTP/TFTP commands.
Click MAINTENANCE > F/W UPLOAD. Follow the instructions in this screen to upload
firmware to your ZyWALL.
1 Only upload firmware for your specific model!
Figure 348 MAINTENANCE > Firmware Upload
The following table describes the labels in this screen.
Bridge When the ZyWALL is in bridge mode, there is no need to select or clear this
radio button.
IP Address Click Bridge to go to the Bridge screen where you can view and/or change the
bridge settings.
Apply Click Apply to save your changes back to the ZyWALL. After you click Apply,
please wait for one minute and use the IP address you configured in the LAN
Interface IP Address field to access the ZyWALL again.
Reset Click Reset to begin configuring this screen afresh.
Table 203 MAINTENANCE > Device Mode (Bridge Mode) (continued)
LABEL DESCRIPTION
Table 204 MAINTENANCE > Firmware Upload
LABEL DESCRIPTION
File Path Type in the location of the file you want to upload in this field or click Browse ... to find it.
Browse... Click Browse... to find the .bin file you want to upload. Remember that you must
decompress compressed (.zip) files before you can upload them.
Upload Click Upload to begin the upload process. This process may take up to two minutes.
To Next Page
Loading...
