Chapter 27 Remote Management Screens
ZyWALL 5/35/70 Series User’s Guide
513
The following table describes the labels in this screen.
27.10 The DNS Screen
Use DNS (Domain Name System) to map a domain name to its corresponding IP address and
vice versa. Refer to Chapter 9 on page 169 for more information.
Click ADVANCED > REMOTE MGMT > DNS to change your ZyWALL’s DNS settings.
Use this screen to set from which IP address the ZyWALL will accept DNS queries and on
which interface it can send them your ZyWALL’s DNS settings. This feature is not available
when the ZyWALL is set to bridge mode.
Table 154 ADVANCED > REMOTE MGMT > SNMP
LABEL DESCRIPTION
SNMP
Configuration
Get Community Enter the Get Community, which is the password for the incoming Get and
GetNext requests from the management station. The default is public and allows all
requests.
Set Community Enter the Set community, which is the password for incoming Set requests from
the management station. The default is public and allows all requests.
Trap
Community Type the trap community, which is the password sent with each trap to the SNMP
manager. The default is public and allows all requests.
Destination Type the IP address of the station to send your SNMP traps to.
SNMP
Service Port You may change the server port number for a service if needed, however you must
use the same port number in order to use that service for remote management.
Service Access Select the interface(s) through which a computer may access the ZyWALL using
this service.
Secure Client IP
Address
A secure client is a “trusted” computer that is allowed to communicate with the
ZyWALL using this service.
Select All to allow any computer to access the ZyWALL using this service.
Choose Selected to just allow the computer with the IP address that you specify to
access the ZyWALL using this service.
Apply Click Apply to save your customized settings.
Reset Click Reset to begin configuring this screen afresh.
To Next Page
Loading...
