Chapter 36 WAN and Dial Backup Setup
ZyWALL 5/35/70 Series User’s Guide
630
36.3.8 Remote Node Profile (3G WAN)
enter 2 in Menu 11 - Remote Node Setup to open Menu 11.2 - Remote Node Profile (3G
WAN) (shown below) and configure the setup for your 3G connection.
Figure 377 Menu 11.2: Remote Node Profile (3G WAN)
The following table describes the fields in this menu.
PIN Code A PIN (Personal Identification Number) code is a key to a 3G card. Without the PIN
code, you cannot use the 3G card.
Enter the 4-digit PIN code (0000 for example) provided by your ISP. If you enter the
PIN code incorrectly, the 3G card may be blocked by your ISP and you cannot use
the account to access the Internet.
If your ISP disabled PIN code authentication, enter an arbitrary number.
When you have completed this menu, press [ENTER] at the prompt “Press ENTER to Confirm…” to
save your configuration, or press [ESC] at any time to cancel.
Table 222 3G Modem Setup in WAN Setup (ZyWALL 5) (continued)
FIELD DESCRIPTION
Menu 11.2 - Remote Node Profile (3G WAN)
Rem Node Name= WAN 2
Active= Yes
Edit IP= No
Outgoing: Edit Script Options= No
My Login= test
My Password= ********
Retype to Confirm= ********
Authen= CHAP/PAP
Pri Phone #= *99#
Always On= No
Session Options:
Edit Filter Sets= No
Idle Timeout(sec)= 100
Press ENTER to Confirm or ESC to Cancel:
Table 223 Menu 11.2: Remote Node Profile (3G WAN)
FIELD DESCRIPTION
Rem Node
Name
Enter a descriptive name for the remote node. This field can be up to eight
characters.
Active Press [SPACE BAR] and then [ENTER] to select Yes to enable the remote node or
No to disable the remote node.
Outgoing
My Login Enter the login name assigned by your ISP for this remote node.
My Password Enter the password assigned by your ISP for this remote node.
To Next Page
Loading...
Need help?
General
