ZyXEL Communications 5 Series - Content Filter Policy: External Database; Figure 191 SECURITY > CONTENT FILTER > Policy > External Database

Chapter 17 Content Filtering Screens
ZyWALL 5/35/70 Series User’s Guide
334
17.5 Content Filter Policy: External Database
Click SECURITY > CONTENT FILTER > Policy and then a policy’s external database
icon to display the following screen.
Use this screen to edit which content categories the content filter policy blocks.
Figure 191 SECURITY > CONTENT FILTER > Policy > External Database
Start IP Address Enter the single IP address or the starting IP address in a range here.
End IP Address Enter the ending IP address in a range here.
Subnet Mask Enter the subnet mask here, if applicable.
Add Click Add to add a new address to the Configured Address box. You
can add multiple addresses, ranges of addresses, and/or subnets.
Modify To edit an existing source or destination address, select it from the box
and click Modify.
Delete Highlight an existing source or destination address from the
Configured Address box and click Delete to remove it.
Apply Click Apply to save your customized settings and exit this screen.
Cancel Click Cancel to exit this screen without saving.
Table 94 SECURITY > CONTENT FILTER > Policy > General (continued)
LABEL DESCRIPTION