To Next Page

To Previous Page

Chapter 47 SNMP Configuration

ZyWALL 5/35/70 Series User’s Guide

712

47.2 SNMP Traps

The ZyWALL will send traps to the SNMP manager when any one of the following events

occurs:

Destination Type the IP address of the station to send your SNMP traps to.

When you have completed this menu, press [ENTER] at the prompt “Press [ENTER] to confirm or

[ESC] to cancel” to save your configuration or press [ESC] to cancel and go back to the previous

screen.

Table 250 SNMP Configuration Menu Fields (continued)

FIELD DESCRIPTION

Table 251 SNMP Traps

TRAP # TRAP NAME DESCRIPTION

0 coldStart (defined in RFC-1215) A trap is sent after booting (power on).

1 warmStart (defined in RFC-1215) A trap is sent after booting (software reboot).

4 authenticationFailure (defined in

RFC-1215)

A trap is sent to the manager when receiving any

SNMP get or set requirements with the wrong

community (password).

6 whyReboot (defined in ZYXEL-

MIB)

A trap is sent with the reason of restart before rebooting

when the system is going to restart (warm start).

6a For intentional reboot: A trap is sent with the message "System reboot by

user!" if reboot is done intentionally, (for example,

download new files, CI command "sys reboot", etc.).

6b For fatal error: A trap is sent with the message of the fatal code if the

system reboots because of fatal errors.

ZyXEL Communications 5 Series User Manual

Questions and Answers: