ZyXEL Communications 5 Series - MAC Filter; Figure 138 WIRELESS > Wi-Fi > MAC Filter; Table 66 WIRELESS > Wi-Fi > MAC Filter

Chapter 12 Wireless Screens
ZyWALL 5/35/70 Series User’s Guide
243
12.3 MAC Filter
The MAC filter screen allows you to configure the ZyWALL to give exclusive access to
specific devices (Allow Association) or exclude specific devices from accessing the
ZyWALL (Deny Association). You need to know the MAC addresses of the devices to
configure this screen.
To change your ZyWALL’s MAC filter settings, click WIRELESS > Wi-Fi > MAC Filter.
The screen appears as shown.
Figure 138 WIRELESS > Wi-Fi > MAC Filter
The following table describes the labels in this menu.
Table 66 WIRELESS > Wi-Fi > MAC Filter
LABEL DESCRIPTION
Active Select or clear the check box to enable or disable MAC address filtering.
Enable MAC address filtering to have the router allow or deny access to wireless
stations based on MAC addresses. Disable MAC address filtering to have the router not
perform MAC filtering on the wireless stations.
Association Define the filter action for the list of MAC addresses in the MAC address filter table.
Select Deny to block access to the router, MAC addresses not listed will be allowed to
access the router. Select Allow to permit access to the router, MAC addresses not
listed will be denied access to the router.
# This is the index number of the MAC address.
User Name Enter a descriptive name for the MAC address.
MAC
Address
Enter the MAC addresses (in XX:XX:XX:XX:XX:XX format) of the wireless stations that
are allowed or denied access to the ZyWALL in these address fields.
Apply Click Apply to save your changes back to the ZyWALL.
Reset Click Reset to begin configuring this screen afresh.