ZyXEL Communications 5 Series - Figure 358 MAINTENANCE > Diagnostics; Table 206 MAINTENANCE > Diagnostics

Chapter 33 Maintenance Screens
ZyWALL 5/35/70 Series User’s Guide
600
Figure 358 MAINTENANCE > Diagnostics
The following table describes the labels in this screen.
Table 206 MAINTENANCE > Diagnostics
LABEL DESCRIPTION
General Setup
Enable Diagnostics Select this option to turn on the diagnostics feature.
Perform Diagnostics
when CPU utilization
exceeds
Set the ZyWALL to generate and send a diagnostic e-mail every time the
CPU usage goes over the specified percent for more than 60 seconds. Enter
0 to have the ZyWALL not generate and send diagnostic files based on CPU
usage going over a specific level.
Display on Console Select this option to have the ZyWALL send diagnostic information through
the console port. To receive the information through the console port, you
still need to configure the mail settings and open a terminal emulation
program on the computer connected to the console port.
To handle the size of the diagnostic file, change your console port speed to
115200 bps (on both the ZyWALL and your terminal emulation program) and
enlarge the console text buffer.
E-mail Settings
Mail Server Enter the server name or the IP address of the mail server for the e-mail
address specified in the Mail Sender field. If this field is left blank, diagnostic
files will not be sent via e-mail.
Mail Subject Type a title that you want to be in the subject line of the diagnostic e-mail
message that the ZyWALL sends.
Mail Sender Enter the e-mail address that you want to be in the from/sender line of the
diagnostic e-mail message that the ZyWALL sends. If you activate SMTP
authentication, the e-mail address must be able to be authenticated by the
mail server as well.