ZyXEL Communications 5 Series - The Telnet Screen; Figure 306 ADVANCED > REMOTE MGMT > SSH; Table 150 ADVANCED > REMOTE MGMT > SSH

Chapter 27 Remote Management Screens
ZyWALL 5/35/70 Series User’s Guide
508
" It is recommended that you disable Telnet and FTP when you configure SSH
for secure connections.
Figure 306 ADVANCED > REMOTE MGMT > SSH
The following table describes the labels in this screen.
27.7 The Telnet Screen
You can use Telnet to access the ZyWALL’s SMT or command line interface. Specify which
interfaces allow Telnet access and from which IP address the access can come.
Click ADVANCED > REMOTE MGMT > TELNET to open the following screen. Use this
screen to specify which interfaces allow Telnet access and from which IP address the access
can come.
Table 150 ADVANCED > REMOTE MGMT > SSH
LABEL DESCRIPTION
Server Host Key Select the certificate whose corresponding private key is to be used to identify the
ZyWALL for SSH connections. You must have certificates already configured in the
My Certificates screen (Click My Certificates and see Chapter 20 on page 399 for
details).
Server Port You may change the server port number for a service if needed, however you must
use the same port number in order to use that service for remote management.
Server Access Select the interface(s) through which a computer may access the ZyWALL using
this service.
Secure Client IP
Address
A secure client is a “trusted” computer that is allowed to communicate with the
ZyWALL using this service.
Select All to allow any computer to access the ZyWALL using this service.
Choose Selected to just allow the computer with the IP address that you specify to
access the ZyWALL using this service.
Apply Click Apply to save your customized settings and exit this screen.
Reset Click Reset to begin configuring this screen afresh.