Chapter 3 Introducing the Web Configurator
ZyWALL 5/35/70 Series User’s Guide
69
Last Connection
Up Time
This displays how long the 3G connection has been up.
Tx Bytes This displays the total number of data frames transmitted.
Rx Bytes This displays the total number of data frames received.
3G Card
Manufacturer
This displays the manufacturer of your 3G card.
3G Card Model This displays the model name of your 3G card.
3G Card Firmware
Revision
This displays the version of the firmware currently used in the 3G card.
3G Card IMEI This displays the International Mobile Equipment Number (IMEI) which is the
serial number of the 3G wireless card. IMEI is a unique 15-digit number used to
identify a mobile device.
SIM Card IMSI This displays the International Mobile Subscriber Identity (IMSI) stored in the SIM
(Subscriber Identity Module) card. The SIM card is installed in a mobile device
and used for authenticating a customer to the carrier network. IMSI is a unique
15-digit number used to identify a user on a network.
3G Card ESN This field is available only when you insert a CDMA (Code Division Multiple
Access) 3G card.
This shows the ESN (Electronic Serial Number) of the inserted CDMA 3G card.
The ESN is the serial number of a CDMA 3G card and is similar to the IMEI on a
GSM or UMTS 3G card.
Enter PIN code
again
If the PIN code you specified in the 3G (WAN 2) screen is not the right one for the
card you inserted, this field displays allowing you to enter the correct PIN code.
Enter the PIN code (four to eight digits) for the inserted 3G card.
Apply Click Apply to save the correct PIN code and replace the one you specified in the
3G (WAN 2) screen.
PUK Code If you enter the PIN code incorrectly three times, the SIM card will be blocked by
your ISP and you cannot use the account to access the Internet. You should get
the PUK (Personal Unblocking Key) code (four to eight digits) from your ISP.
Enter the PUK code to enable the SIM card. If an incorrect PUK code is entered
10 times, the SIM card will be disabled permanently. You then need to contact
your ISP for a new SIM card.
New PIN Code Configure a PIN code for the SIM card. You can specify any four to eight digits to
have a new PIN code or enter the previous PIN code.
Confirm New PIN
Code
Enter the PIN code again for confirmation.
Apply Click Apply to save your changes in this section.
Reset budget
counters, resume
budget control
This field displays if you have enabled budget control but insert a 3G card with a
different user account from the one for which you configured budget control.
Select this option to have the ZyWALL do budget calculation starting from 0 but
use the previous settings.
Resume budget
control
This field displays if you have enabled budget control but insert a 3G card with a
different user account from the one for which you configured budget control.
Select this option to have the ZyWALL keep the existing statistics and continue
counting.
Table 4 Web Configurator HOME Screen in Router Mode (continued)
LABEL DESCRIPTION
To Next Page
Loading...
