Chapter 7 Home Networking
VMG8924-B10A and VMG8924-B30A Series User’s Guide
125
7.8 The STB Vendor ID Screen
Set Top Box (STB) devices with dynamic IP addresses sometimes don’t renew their IP addresses
before the lease time expires. This could lead to IP address conflicts if the STB continues to use an
IP address that gets assigned to another device. Use this screen to list the Vendor IDs of connected
STBs to have the Device automatically create static DHCP entries for them when they request IP
addresses.
Click Network Setting > Home Networking > STB Vendor ID to open this screen.
Figure 60 Network Setting > Home Networking > STB Vendor ID
The following table describes the labels in this screen.
7.9 The 5th Ethernet Port Screen
If you use a DSL connection, you can configure your Ethernet WAN port as an extra LAN port. This
Gigabit Ethernet port provides faster transmission speeds. Click Network Setting > Home
Networking > 5th Ethernet Port to open this screen.
Offer Public IP
by DHCP
Select the checkbox to enable the Device to provide public IP addresses by DHCP server.
Enable ARP
Proxy
Select the checkbox to enable the ARP (Address Resolution Protocol) proxy.
Apply Click Apply to save your changes.
Cancel
Click Cancel to exit this screen without saving.
Table 34 Network Setting > Home Networking > Additional Subnet (continued)
LABEL DESCRIPTION
Table 35 Network Setting > Home Networking > STB Vendor ID
LABEL DESCRIPTION
Vendor ID 1 ~
5
Enter the STB’s vendor ID.
Apply Click Apply to save your changes.
Cancel
Click Cancel to exit this screen without saving.
To Next Page
Loading...
Need help?
General
