Chapter 31 Remote Management
VMG8924-B10A and VMG8924-B30A Series User’s Guide
293
31.4 The Add Trust Domain Screen
Use this screen to configure a public IP address which is allowed to access the Device. Click the Add
Trust Domain button in the Maintenance > Remote MGMT > Turst Domain screen to open the
following screen.
Figure 170 Maintenance > Remote MGMT > Trust Domain > Add Trust Domain
The following table describes the fields in this screen.
Table 140 Maintenance > Remote MGMT > Trust Domain > Add Trust Domain
LABEL DESCRIPTION
IPv4 Address
Enter a public IPv4 IP address which is allowed to access the service on the Device from the
WAN.
Apply Click Apply to save your changes back to the Device.
Cancel Click Cancel to restore your previously saved settings.
To Next Page
Loading...
Need help?
General
