ABB ACS880 - Page 250

Def / Type
FbEq 16b / 32b
DescriptionName / Range /
Selection
No.
0.00 s / real32(Visible when 14.1 Module 1 type = FIO-01)
Defines the activation delay for relay output RO1.
Status of
selected source
RO status
t
On
t
Off
t
Off
t
On
Time
1
0
0
1
t
On
= 14.35 RO1 ON delay
t
Off
= 14.36 RO1 OFF delay
RO1 ON delay14.35
10 = 1 s / 100 = 1 sActivation delay for RO1.0.00 ... 3000.00 s
0.00 s / real32(Visible when 14.1 Module 1 type = FDIO-01)
Defines the deactivation delay for relay output RO1.
See parameter 14.35 RO1 ON delay.
RO1 OFF delay14.36
10 = 1 s / 100 = 1 sDeactivation delay for RO1.0.00 ... 3000.00 s
100.000 / real32(Visible when 14.1 Module 1 type = FAIO-01)
Defines the real value that corresponds to the maximum
analog input AI1 value defined by parameter 14.34 AI1
max.
See the drawing at parameter 14.35 AI1 scaled at AI1
min.
AI1 scaled at AI1 max14.36
1 = 1 / 1000 = 1Real value corresponding to maximum AI1 value.-32768.000 ...
32767.000
0.00 s / real32(Visible when 14.1 Module 1 type = FIO-01)
Defines the deactivation delay for relay output RO1.
See parameter 14.35 RO1 ON delay.
RO1 OFF delay14.36
10 = 1 s / 100 = 1 sDeactivation delay for RO1.0.00 ... 3000.00 s
Not energized /
uint32
(Visible when 14.1 Module 1 type = FDIO-01)
Selects a drive signal to be connected to relay output
RO2.
For the available selections, see parameter 14.11 DIO1
output source.
RO2 source14.37
Not energized /
uint32
(Visible when 14.1 Module 1 type = FIO-01)
Selects a drive signal to be connected to relay output
RO2.
For the available selections, see parameter 14.11 DIO1
output source.
RO2 source14.37
0.00 s / real32(Visible when 14.1 Module 1 type = FDIO-01)
Defines the activation delay for relay output RO2. See
parameter 14.35 RO1 ON delay.
RO2 ON delay14.38
10 = 1 s / 100 = 1 sActivation delay for RO2.0.00 ... 3000.00 s
0.00 s / real32(Visible when 14.1 Module 1 type = FIO-01)
Defines the activation delay for relay output RO2. See
parameter 14.35 RO1 ON delay.
RO2 ON delay14.38
10 = 1 s / 100 = 1 sActivation delay for RO2.0.00 ... 3000.00 s
250 Parameters