ABB ACS880 - Page 362

Def / Type
FbEq 16b / 32b
DescriptionName / Range /
Selection
No.
6Digital input DI5 (10.2 DI delayed status, bit 4).DI5
7Digital input DI6 (10.2 DI delayed status, bit 5).DI6
10Digital input/output DIO1 (11.2 DIO delayed status, bit
0).
DIO1
11Digital input/output DIO2 (11.2 DIO delayed status, bit
1).
DIO2
See Terms and abbreviations (page 169).Other [bit]
-300.0 % / real32Defines a minimum torque limit for the drive (in percent
of nominal motor torque). See diagram at parameter
30.18 Minimum torque sel.
The limit is effective when
• the source selected by 30.18 Minimum torque sel
is 0, or
• 30.18 is set to Minimum torque 1.
Note: Do not set this parameter to 0% in an attempt
to prevent reverse rotation. In an open-loop application,
that is likely to prevent the motor from stopping
altogether. To prevent reverse rotation, use the
speed/frequency limits in this parameter group, or
parameters 20.23/20.24.
Minimum torque 130.19
- / -Minimum torque limit 1. For scaling, see parameter
46.3.
-1600.0 ... 0.0 %
300.0 % / real32Defines a maximum torque limit for the drive (in
percent of nominal motor torque). See diagram at
parameter 30.18 Minimum torque sel.
The limit is effective when
• the source selected by 30.25 Maximum torque sel
is 0, or
• 30.25 is set to Maximum torque 1.
Maximum torque 130.20
- / -Maximum torque 1. For scaling, see parameter 46.3.0.0 ... 1600.0 %
Minimum torque 2 /
uint32
Defines the source of the minimum torque limit for the
drive (in percent of nominal motor torque) when
• the source selected by parameter 30.18 Minimum
torque sel is 1, or
• 30.18 is set to Minimum torque 2 source
See diagram at 30.18 Minimum torque sel.
Note: Any positive values received from the selected
source are inverted.
Minimum torque 2
source
30.21
0None.Zero
112.12 AI1 scaled value (see page ?).AI1 scaled
212.22 AI2 scaled value (see page ?).AI2 scaled
362 Parameters