ABB ACS880 - Page 413

Def / Type
FbEq 16b / 32b
DescriptionName / Range /
Selection
No.
0NoneZero
11.1 Motor speed used (page 174).Motor speed used
31.6 Output frequency (page 174).Output frequency
41.7 Motor current (page 174).Motor current
61.10 Motor torque (page 174).Motor torque
71.11 DC voltage (page 175).DC voltage
81.14 Output power (page 175).Power inu out
1023.1 Speed ref ramp input (page 311).Speed ref ramp in
1123.2 Speed ref ramp output (page 311).Speed ref ramp out
1224.1 Used speed reference (page 318).Speed ref used
1326.2 Torque reference used (page 338).Torq ref used
1428.2 Frequency ref ramp output (page 347).Freq ref used
1640.1 Process PID output actual (page 420).Process PID out
1740.2 Process PID feedback actual (page 420).Process PID fbk
1840.3 Process PID setpoint actual (page 420).Process PID act
1940.4 Process PID deviation actual (page 420).Process PID dev
See Terms and abbreviations (page 169).Other [value]
201.70 Ambient temperature % (page 177).
The amplitude range of 0…100% corresponds to
0…60 °C or 32…140 °F.
Ambient
temperature
100.00 / real32Defines the signal value that corresponds to 100%
amplitude.
AL2 signal scaling36.7
1 = 1 / 100 = 1Signal value corresponding to 100%.0.00 ... 32767.00
- / uint16Determines whether amplitude loggers 1 and 2 are
active continuously or only when the drive is
modulating.
Logger function36.8
0 = Amplitude logger 1 active continuously
1 = Amplitude logger 1 active only when the drive is
modulating
AL1b0
0 = Amplitude logger 2 active continuously
1 = Amplitude logger 2 active only when the drive is
modulating
AL2b1
Reservedb2…15
1 = 10000h…FFFFh
Done / uint16Resets the peak value logger and/or amplitude logger
2.
(Amplitude logger 1 cannot be reset.)
Reset loggers36.9
0Reset completed or not requested (normal operation).Done
1Reset both the peak value logger and amplitude logger
2.
All
2Reset the peak value logger.PVL
Parameters 413