EasyManua.ls Logo

ABB ACS880 - Page 507

ABB ACS880
764 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Def / Type
FbEq 16b / 32b
DescriptionName / Range /
Selection
No.
None / uint32Parameters 61.4561.50 preselect data to be sent in
data sets 2 and 4 to the external controller. These data
sets are used in ModuleBus communication with a
“standard drive” (60.50 DDCS controller drive type =
ABB standard drive). Parameters 61.9561.100 display
the data to be sent to the external controller. If no data
has been preselected, the value to be sent can be
written directly into these parameters. For example,
this parameter preselects the data for word 1 of data
set 2. Parameter 61.95 Data set 2 data 1 value displays
the selected data in integer format. If no data is
preselected, the value to be sent can be written directly
into parameter 61.95.
Data set 2 data 1
selection
61.45
0None.None
1Control Word (16 bits)CW 16bit
4Status Word (16 bits)SW 16bit
5Actual value ACT1 (16 bits)Act1 16bit
6Actual value ACT2 (16 bits)Act2 16bit
See Terms and abbreviations (page 169).Other [value]
None / uint32Preselects the data to be sent as word 2 of data set 2
to the external controller.
See also parameter 61.96 Data set 2 data 2 value.
For the selections, see parameter 61.45 Data set 2 data
1 selection.
Data set 2 data 2
selection
61.46
None / uint32See parameter 61.45 Data set 2 data 1 selection.Data set 2 data 3
selection
61.47
None / uint32See parameter 61.45 Data set 2 data 1 selection.Data set 4 data 3
selection
61.50
None / uint32Parameters 61.5161.74 preselect data to be sent in
data sets 11, 13, 15, 17, 19, 21, 23 and 25 to the external
controller.
Parameters 61.10161.124 display the data to be sent
to the external controller. If no data has been
preselected, the value to be sent can be written directly
into these parameters.
For example, this parameter preselects the data for
word 1 of data set 11. Parameter 61.101 Data set 11 data
1 value displays the selected data in integer format. If
no data is preselected, the value to be sent can be
written directly into parameter 61.101.
Data set 11 data 1
selection
61.51
0None.None
1Control Word (16 bits)CW 16bit
4Status Word (16 bits)SW 16bit
5Actual value ACT1 (16 bits)Act1 16bit
6Actual value ACT2 (16 bits)Act2 16bit
See Terms and abbreviations (page 169).Other [value]
Parameters 507

Table of Contents

Other manuals for ABB ACS880

Related product manuals