ABB ACSM1 - Page 114

Parameters and firmware blocks
114
12.09 DIO3 F MIN FW block: DIO3 (see above)
Defines the minimum value for frequency output (when 12.03 DIO3 CONF is set to (2) FREQ
OUTPUT).
3…32768 Hz Minimum DIO3 output frequency.
12.10 DIO3 F MAX SCALE FW block: DIO3 (see above)
Defines the real value that corresponds to the maximum frequency output value defined by
parameter 12.08 DIO3 F MAX.
0…32768 Real value corresponding to value of parameter 12.08.
12.11 DIO3 F MIN SCALE FW block: DIO3 (see above)
Defines the real value that corresponds to the minimum frequency output value defined by
parameter 12.09 DIO3 F MIN. See parameter 12.10 DIO3 F MAX SCALE.
0…32768 Real value corresponding to value of parameter 12.09.
Firmware block:
RO
(5)
Connects an actual signal to the relay
output. The block also shows the
relay output status.
Block outputs located in other
parameter groups
2.02 RO STATUS (page 80)
12.12 RO1 OUT PTR FW block: RO (see above)
Selects a drive signal to be connected to relay output RO1.
Bit pointer: Group, index and bit
Firmware block:
DI
(4)
Shows the status of the digital inputs.
Inverts the status of any DI if desired.
Block outputs located in other
parameter groups
2.01 DI STATUS (page 80)
DIO3 (Hz)
DIO3 (real)
12.09
12.11 12.10
DIO3 (Hz)
DIO3 (real)
12.08
12.09
12.10 12.11
12.08
RO
17
TLF7 2 msec (2)
< 12.12 RO1 OUT PTR
[ BRAKE COMMAND.0 ]
(4 / 3.15.0)
2.02 RO STATUS
DI
16
TLF7 2 msec (1)
12.13 DI INVERT MASK
[ 00 0 000 ]
2.01 DI STATUS