ABB ACSM1 - Page 158

Parameters and firmware blocks
158
(2) HIGH When the signal selected by parameter 33.10 SUPERV3 ACT
exceeds the value of parameter 33.11 SUPERV3 LIM HI, bit 2 of 6.14
SUPERV STATUS is activated.
(3) ABS LOW When the absolute value of the signal selected by parameter 33.10
SUPERV3 ACT falls below the value of parameter 33.12 SUPERV3
LIM LO, bit 2 of 6.14 SUPERV STATUS is activated.
(4) ABS HIGH When the absolute value of the signal selected by parameter 33.10
SUPERV3 ACT exceeds the value of parameter 33.11 SUPERV3 LIM
HI, bit 2 of 6.14 SUPERV STATUS is activated.
33.10 SUPERV3 ACT FW block: SUPERVISION (see above)
Selects the signal to be monitored by supervision 3. See parameter 33.09 SUPERV3 FUNC.
Value pointer: Group and index
33.11 SUPERV3 LIM HI FW block: SUPERVISION (see above)
Sets the upper limit for supervision 3. See parameter 33.09 SUPERV3 FUNC.
-32768…32768 Upper limit for supervision 3.
33.12 SUPERV3 LIM LO FW block: SUPERVISION (see above)
Sets the lower limit for supervision 3. See parameter 33.09 SUPERV3 FUNC.
-32768…32768 Lower limit for supervision 3.