NoteAction
xx1100000008
Required oil level:
• up to the lower edge of the oil plug
hole.
Note
The oil plugs on gearbox axis 1 are now on
top.
5
How to fill oil is described in section:
• Changing the oil, axis-1 gearbox
on floor mounted robots on
page 150
Add oil if required.6
Tightening torque:
• 3 Nm
Refit the oil plug.
Note
Only valid for Other design than Type C:
Before refitting the oil plug in the gearbox,
always replace the oil plug sealing washer
with a new one. If not there is a risk of
leakage.
7
120 3HAC033453-001 Revision: H
© Copyright 2009-2013 ABB. All rights reserved.
3 Maintenance
3.3.1 Inspecting oil level, axis 1 gearbox
Continued
To Next Page
Loading...
