3.4.4 Changing the oil, axis-2 gearbox
Location of oil plugs
The axis-2 gearbox is located in the lower arm rotational center, underneath the
motor attachment.
Oil plugs are shown in the figure.
xx0800000305
Oil plug, filling (draining when suspended mounted)A
Oil plug, draining (filling when suspended mounted) (Quick connect fitting)B
Required equipment
NoteEquipment
3HAC029646-001Only valid for Other design than Type C:
Oil plug sealing washer, gearbox
Information about the oil is found in Technical
reference manual - Lubrication in gearboxes.
Lubricating oil
See Type and amount of oil in gearboxes on
page 148.
The capacity of the vessel must be sufficient
to take the complete amount of oil.
Oil collecting vessel
To be fitted on a hose, and then used for
draining connected to the quick connect fit-
ting.
Nipple (TEMA IF 3820 S06)
See Location of oil plugs on page 162.
Content is defined in section Standard tools
on page 341.
Standard toolkit
Continues on next page
162 3HAC033453-001 Revision: H
© Copyright 2009-2013 ABB. All rights reserved.
3 Maintenance
3.4.4 Changing the oil, axis-2 gearbox
To Next Page
Loading...
