8.7 Special tools
General
All service instructions contain lists of tools required to perform the specified
activity. The required tools are a sum of standard tools, defined in the section
Standard tools on page 341, and of special tools, listed directly in the instructions
and also gathered in this section.
Measuring tools, play
The tools listed for measuring the play are used after service work on axes 5 and
6.
Art. no.Robot variantDescription
3HAB1611-6IRB 4600 - 60/2.05, -45/2.05, -40/2.55Measuring tool, play
3HAB6337-1IRB 4600 - 20/2.50Measuring tool, play
Special tools
The following table specifies the special tools required during several of the service
procedures. The tools may be ordered separately and are also specified directly
in concerned instructions in the product manual.
Art. no.QtyDescription
-2 pcsGuide pins, removal/refitting
of axis 1 gearbox
-2 pcsGuide pins, removal/refitting
of axis 3 gearbox
Calibration equipment, Levelmeter (alternative method)
The following table specifies the calibration equipment required when calibrating
the robot with the alternative method, Levelmeter Calibration.
NoteArt. no.Description
68080011-LPAngle bracket
3HAC13908-9Calibration bracket
3HAC13908-4Calibration tool ax1
Includes one sensor.6369901-347Levelmeter 2000 kit
3HAC13908-5Measuring pin
68080011-GMSensor fixture
3HAC0392-1Sensor plate
3HAC13908-1Sync. adapter
3HAC68080011-GUTurn disk fixture
Continues on next page
342 3HAC033453-001 Revision: H
© Copyright 2009-2013 ABB. All rights reserved.
8 Reference information
8.7 Special tools
To Next Page
Loading...
