Other design than Type C
xx0800000400
FrameA
Radial sealingB
O-ringC
Axis-1 gearboxD
Washer (21 pcs)E
Attachment screws M8x80 quality Steel 12.9 Gleitmo (21 pcs)F
Required equipment
NoteEquipment
See Spare part list on page 345.Gearbox
Type C: M10 (2 pcs)Guide pins
Other design than Type C: M8 (2 pcs)
Used to guide the gearbox during removal/re-
fitting.
Content is defined in section Standard tools
on page 341.
Standard toolkit
These procedures include references to the
tools required.
Other tools and procedures may be re-
quired. See references to these procedures
in the step-by-step instructions below.
Continues on next page
298 3HAC033453-001 Revision: H
© Copyright 2009-2013 ABB. All rights reserved.
4 Repair
4.8.1 Replacing gearbox axis 1
Continued
To Next Page
Loading...
