NoteAction
xx0800000440
Fit a lifting lug in the uppermost hole for
the attachment screws securing the base,
as shown in the figure.
2
Parts:
• A: Roundsling
• B: Lifting lug
• C: Uppermost attachment hole for
securing the base
• D: Gearbox axis 1
xx0800000441
Only valid for Other design than Type C:
Note
Check, when fitting the lifting lug, that both
oil plugs will be placed in the correct posi-
tion after the gearbox is fitted as shown in
the figure. The oil plugs shall be placed in
the openings in the frame.
3
Parts:
• A: Opening for oil plug in frame
• B: Oil plug
See the figure in:
• Location of gearbox on page 297
Replace o-ring if damaged.
Apply grease on the o-ring.4
Clean all assembly surfaces.5
Remove any painting from the assembly
surfaces, with a knife.
Always use guide pins in pairs!Fit guide pins into two of the holes for the
attachment screws.
6
Continues on next page
3HAC033453-001 Revision: H 301
© Copyright 2009-2013 ABB. All rights reserved.
4 Repair
4.8.1 Replacing gearbox axis 1
Continued
To Next Page
Loading...
