xx0900000137
Fanbox (motor axis 1)A
Groove in the connectorB
Back plateC
Part of the fanbox that can be removed, if needed.D
Required equipment
NoteArt. no.Equipment
For Spare part no. see chapter Spare
parts, section:
• Spare part list on page 345
-Cooling fan axis 1, set
For Spare part no. see chapter Spare
parts, section:
• Spare part list on page 345
-Cooling fan axis 2, set
Loctite 243. Used for the three tightening
screws.
-Locking liquid
Content is defined in section Standard
tools on page 341.
-Standard toolkit
See chapter Circuit diagram on page 369.-Circuit diagram
These procedures include references to
the tools required.
Other tools and procedures
may be required. See refer-
ences to these procedures
in the step-by-step instruc-
tions below.
Continues on next page
92 3HAC033453-001 Revision: H
© Copyright 2009-2013 ABB. All rights reserved.
2 Installation and commissioning
2.5.1 Installation of cooling fan for motors (option)
Continued
To Next Page
Loading...
