Installation, fan on motor axis 2
Use this procedure to install the cooling fan on motor axis 2.
NoteAction
DANGER
Turn off all:
• electric power supply to the robot
• hydraulic pressure supply to the robot
• air pressure supply to the robot
Before entering the robot working area.
1
See the figure in:
• Cooling fan on page 91
Remove the back plate of the fanbox.2
Place the fanbox around motor axis 1.3
See the figure in:
• Cooling fan on page 91
Refit the back plate of the fanbox.4
Fit the fanbox with two attachment screws
M6x30.
5
xx0900000405
Connect the fan connector to motor and fan.6
Parts:
• A: Connector, signal
• B: Connector, power
• C: Fan cable
• D: Connector, fan
• E: Cable gland
• F: Motor cover, with fan cable
Continues on next page
3HAC033453-001 Revision: H 95
© Copyright 2009-2013 ABB. All rights reserved.
2 Installation and commissioning
2.5.1 Installation of cooling fan for motors (option)
Continued
To Next Page
Loading...
