3 Maintenance
3.3.7. Inspection, cable harness
1093HAC027151-001 Revision: B
© Copyright 2006-2008 ABB. All rights reserved.
xx0600003078
The figure shows the upper routing of the cable harness.
Required equipment
A Cable harness
B Metal clamp, at gearbox axis 3
C Attachment screws, metal clamp at gearbox axis 3, M6x16 quality 8.8 (2 pcs)
D Metal clamp, lower arm (2 pcs)
E Attachment screws, metal clamp lower arm, M6x16 quality 8.8 (2+2 pcs)
F Metal clamp, armhouse
G Attachment screws, metal clamp armhouse, M6x16 quality 8.8 (2 pcs)
Equipment, etc. Art.no. Note
Standard toolkit - Detailed in section Standard
toolkit on page 265.
Other tools and procedures
may be required. See
references to these
procedures in the step-by-
step instructions below.
These procedures include
references to the tools required.
Circuit diagram See chapter Circuit diagram.
Continued
Continues on next page
To Next Page
Loading...
