Preparations before refitting the parallel rod, lower end
NoteAction
xx1500002744
Remove the strap which was used to keep
bearing, thrust washer and cover washer
in position.
1
xx1500002098
Right sideLeft side
Cover washerThrust washer
Remove the thrust washer and cover
washer, and wipe them clean.
Note
Make a note on which side the covers are
placed.
2
Wipe the shafts and the holes for the shafts
clean.
3
Mercasol
xx1500002100
Apply corrosion protection on both sides
of the bearings, and on all machined sur-
faces on the parallel rod.
4
Continues on next page
Product manual - IRB 8700 481
3HAC052853-001 Revision: F
© Copyright 2015-2018 ABB. All rights reserved.
4 Repair
4.5.7 Replacing the parallel arm
Continued
To Next Page
Loading...
