ABB IRB 8700 Series - Page 61

NoteAction
A
B
C
xx1400002588
CE labelA
Fork lift accessory pocket (4
pcs)
B
Attachment screws MC6S
20x60 8.8 (2 pcs x4)
C
Attach the fork lift accessory pockets (4 pcs).
Note
Make sure that the original screws are used. If
need to replace any of the screws, use screws
with equivalent quality.
DANGER
Never attach a fork lift pocket with only one attach-
ment screw.
5
Tightening torque: 300 NmSecure the fork lift accessory pockets.6
CAUTION
Do not lift the robot at this point; the robot is still
secured to the foundation.
The remaining attachment screws, that secure
the robot to the foundation, will be removed after
the fork lift truck has its forks inserted into the
fork lift accessory pockets.
7
Lifting with the fork lift accessory set
Preparations before lifting
NoteAction
Note
No extra load is permitted on the
robot.
DressPack cable package can stay
fitted as long as the tool has been
removed.
Make sure that any tool attached on the turning
disc, has been removed before lifting.
Note
No tool is permitted to be fitted on the robot, when
lifting the robot with the fork lift accessory set.
1
Continues on next page
Product manual - IRB 8700 61
3HAC052853-001 Revision: F
© Copyright 2015-2018 ABB. All rights reserved.
2 Installation and commissioning
2.3.1 Lifting the robot with fork lift accessory set installed
Continued